Aleran
Waterslide 1/76-1/72-20mm Decals |
|
|
Aleran
Decals are imported from the USA. Milicast
is the sole European Distributtor for this superb product.
Each sheet has on average
enough markings to complete upto ten models.
We
recommended this product without reservation.
Please
note that if only buying decals sets then Shipping
is either 10% (Minimum £1.00) or you can use our usual
postal rates....which ever is lower to you!
|
|
Instructions
& Helpful Hints when using Decals
Decals
sre best applied onto a glossy surface. Either to gloss paint surface
or by spraying a clear gloss coat prior to applying decals.
Carefully
cut the required decal, cutting as close to to the image as possible,
then dip into tap water for 10-20 seconds. (Warm/tepid water is
best for disolving the glue but care must be taken for if they slip
from the paper and sink, they usually "foldup" and are
almost impossible to use therafter).
Using tweezers, remove the decal and lay on a clean work surface
for a further 15-30 seconds. Slide the decal off the backing paper
onto the model and when correctly positioned, gently blot away the
excess water.
Allow
the decal to fully dry out before applying any finishing coats to
seal the decal. Please note that Humbrol Matt Varnish
should only be applied by airbush. Any other mothod will result
in the decal dissolving!
Decal
setting solutions such as Solvaset are good for softening the decal
in order to allow it to conform to most surface features such as
rivets, scribe lines, etc., Once the solution has been applied do
not touch until it dries, even if appears to have wrinkled as you
may tear the decal. As it dries, it will smooth out.
|
